NFS-HLSC (Discontinued Products)

■ Discontinued: December 28, 2022

MKY36 mounted
ARM-based microcontroller board

NFS-HLSC is a microcontroller board for HLS evaluation which equips MKY36,
an HLS master IC.
Also, STM32F207 (ARM®Cortex®-M3 processor) is mounted on the board and connected to MKY36 via FSMC bus (memory interface bus.)
StepTechnica's original debug monitoring software is implemented in internal flash memory of Cortex-M3 processor to use HLS instantly with connecting to a PC.
USB (High Speed USB) is equipped as an interface for PC.
This is bus-powered USB device.
You can rewrite your original program to internal flash ROM of Cortex-M3 processor
via JTAG in order to perform the simulation same as real operation.
ARM®Cortex®-M3 are registered trademarks of ARM Limited in the EU and other countries.

Main specifications

Item Specifications
MCU STM32F207 (ST Microelectronics)
Clock frequency Input clock frequency: 8 MHz
Operating clock frequency: 120 MHz
FSMC bus clock frequency: 120 MHz
Flash ROM 256 KB (STM32F207 internal ROM)
RAM 128 KB (STM32F207 internal RAM)
Programming to MCU JTAG
Type and number
of IC mounted		 MKY36 × 1 pc
Communication method Full-duplex/Half-duplex
Communication rate 12/6/3 Mbps (Set by MKY36 register)
Interrupt factor MKY36 INT0 and INT1
Switches USER SW 8 bit × 2 pcs
LED POWER
USER LED
SCAN
CHK2
CHK1		 (Green)
(Red)
(Green)
(Red)
(Yellow)		 +5.0 V
4 pcs
MKY36
MKY36
MKY36		 Power supply

SCAN
CHK2
CHK1		  
Connectors MicroUSB connector: For PC communication and power supply
HLS communication connector: RJ45 type × 2 pcs
JTAG connector: Not pre-equipped
Expansion (GPIO) connector: Not pre-equipped
Power supply +5.0 V (Supplied from MicroUSB connector)
Size 80 mm × 100 mm
Weight 40.5 g
Operating conditions Temperature: 10℃ to 50℃
Humidity: 0% to 90% (With no condensation)
Consumption current +5.0 V ± 5% 400 mA or lower

Downloads (Documents)